How to Repair or Make Network Cable

How to Repair or Make Network Cable

Learn how to properly crimp network cables so you can make your own custom lengths or repair broken cables!

Music track:
“Hustle” Kevin MacLeod (incompetech.com)
Licensed under Creative Commons: By Attribution 3.0

Categories: Computer System

About Author

Comments

  1. gilrstein
    gilrstein 30 April, 2022, 16:03

    Wouldn't you also need to strip the ends of the little wires?

    Reply this comment
  2. hadi
    hadi 30 April, 2022, 16:03
  3. Adam Trout
    Adam Trout 30 April, 2022, 16:03

    Thank you SO MUCH for this, Rick!

    Reply this comment
  4. Chris Osorio
    Chris Osorio 30 April, 2022, 16:03

    how the fuck am i suppose to get one of those clippers lol

    Reply this comment
  5. VIP Electrician Brisbane
    VIP Electrician Brisbane 30 April, 2022, 16:03

    This is a perfect video.Loved it.?

    Reply this comment
  6. Evan O
    Evan O 30 April, 2022, 16:03

    this video was my guide when i replaced my ethernet tip. thank you!

    Reply this comment
  7. Adonomar
    Adonomar 30 April, 2022, 16:03

    if i dont have this crimper how could i make the last part??

    Reply this comment
  8. Mamoo
    Mamoo 30 April, 2022, 16:03

    thank you this helped a lot 🙂

    Reply this comment
  9. Scrap5000
    Scrap5000 30 April, 2022, 16:03

    That was awesome, thanks!

    Reply this comment
  10. The Dude
    The Dude 30 April, 2022, 16:03

    If you are in Australia or any other country that uses the T568A standard (as opposed to the T568B shown here) swap the orange and green pairs on both ends. Makes no electrical difference and the cables are interchangeable but it's what the structured cabling standard (AS/ACIF S009) specifies.
    The advantage of A is the inner two pairs map directly to phone colour code wiring.
    Also if you terminate one end as A and the other as B you've made a crossover cable.

    Reply this comment
  11. Krishna Kolakaluri
    Krishna Kolakaluri 30 April, 2022, 16:03

    You can also make a cross cable out of this, so that you can connect two end terminals together, if in case you dont have a switch.

    Reply this comment

Write a Comment

<