Paintless Dent Repair service Employing a Heat Gun and a Can of Compressed Gas Duster

Paintless Dent Repair service Employing a Heat Gun and a Can of Compressed Gas Duster

Can you fix dents in an car with a hair dryer and a can of compressed air? Of course and no. It is dependent on the site and severity of the hurt. But as I have demonstrated, with a warmth gun, $9 worthy of of Endust Duster, and about 15 minutes, you can reach some outstanding results.

Study far more at… http://site.yagelski.com/2011/10/paintless-dent-fix-working with-warmth-gun.html

Responses to the most frequent criticisms:

Q. Why did not you just thrust the dent out from at the rear of?
A. This is a hybrid vehicle and there is A/C tools for battery cooling that is positioned in between the sheet metallic and the interior end. The dent was basically not available from the within.

Q. Why did not you just use a toilet plunger and pull the dent out?
A. That may well have labored on the more substantial of the two dents, but the surface area region of the more compact dent would have manufactured that unattainable.

Q. This online video and pictures of the dents have been Photoshopped and faked!
A. Unquestionably not. I will gladly attest that this online video and the illustrations or photos of the dent, in advance of and immediately after, have not been retouched. I also have a witness who observed the procedure and would attest the identical.

Q. “Tapping” the panel like you did in the online video would have popped the dent out with out the heating and cooling.
A. My tries to pop the dent out with persuasive tapping by hand and a rubber mallet prior to the heating / cooling did not have any affect.

Q. This procedure did not enable, you can still see the dents!
A. Of course. if you appear carefully you can still see the more compact of the two dents. Nevertheless, the more substantial of the two is not distinguishable to the casual observer. This procedure manufactured a important improvement to the overall look of the two dents. It is not a manufacturing facility great fix, but this is not a valuable vehicle either. I could not justify the cost of a qualified human body shop for a vehicle that is 7 years previous and +150,000 miles. This procedure presented a excellent alternative.

Categories: Computer System

About Author

Write a Comment

<